LINEAR DRAINAGE:
SE-low System
General information:
- Construction: A drainage channel consists of a drain and a cast iron COC grating.
- Material: The drain is made of polymer concrete with steel edging strips which enable gratings to be screw fixed or with ductile cast iron edging strips which enable gratings to be snap fastened, screw fixed or installed universally (screw fixed or snap fastened or with the application of double installation method (screw and snap).
- Channels with steel galvanised or stainless edges are intended for class C250, channels with cast iron edges are intended for class E600.
- Dimensions: SE low channels are available in a non-sloped version (without a bottom slope) in two construction (outer) heights: 8 and 10cm.
- It is possible to make an opening in the channel bottom and mount a drain connector.
- In case of channels 0.5m long it is possible to connect a drainage channel of the same parameters at an angle of 90°.
- It is possible to divert the flow using a special connector.
- Inspection and cleaning: along the whole length of the system
- Max. load class: E600.
- Installation of units: must allow for min. 0.2% slope. Recommended slope min. 0,5%.
IMPORTANT: SE low channels are „M” type channels according to PN-EN1433 (require an additional support), therefore they require a concrete apron. Channels should be installed according to SE/SSE LINEAR DRAINAGE INSTALLATION MANUAL
Functions of the system:
Collecting and disposing storm water from the surface of roads, streets and yards into a sewerage or storm drainage network, a combined sewer system or directly to the receiver.
Application scope:
Type “M” units – groups 1-5 of application areas with load class A15-E600 according to PN-EN 1433, among others industrial areas of heavy traffic and high load etc.
Special area of application:
Collecting and disposing storm water from circulation routes for pedestrian and bicycle traffic , green areas e.g. parks, squares, domestic areas, including domestic garages, kerb zones, shoulders not burdened with traffic, car parks or parking bays for passenger cars, carriageways, shoulders and car parks for any type of road vehicles, areas subject to heavy loads caused by vehicular traffic e.g. ports and docks.
- Polymer concrete drain
- Cast iron grating